Anetsberger-brothers 14G Manuel d'utilisateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
18
FRYER TROUBLESHOOTING GUIDE
PROBLEM CAUSE REMEDY
All service (repairs or part replacement) must be performed by a qualified Service Agency.
Pilot flame does not
stay lighted.
1. Dirty/sooty pilot burner.
2. Low gas supply pressure [less than 6
W.C. for natural gas; (11 W.C. for pro-
pane) when
all other gas-powered equip-
ment is operating].
3. Pilot flame too small to heat the thermo-
couple.
4. Pilot flame ‘wavering’ (being blown about
by a draft).
5. Improper thermocouple output voltage
(must be at least 10 millivolts, measured at
the thermocouple junction block).
6. High-limit thermostat problem has shut off
the gas.
1. Clean the pilot burner. Perform
the Lighting Procedure.
2. Measure the gas supply pres-
sure.
Contact your local gas supplier
to obtain adequate gas supply
pressure.
3. Adjust the pilot valve (part of
the gas control valve) to in-
crease the flame size: Un-
screw and retain the slotted
threaded cover; turn the pilot
valve adjustment screw two
turns counterclockwise;
reinstall the threaded cover.
4. Block or redirect the draft, to
keep the flame burning steadily.
5. Replace the thermocouple.
6. Check for, and repair, any dam-
aged high-limit thermostat wir-
ing. [For model 14GSU fryer
ONLY: Press the reset push-
button on the high-limit thermo-
stat control. Perform the Light-
ing Procedure, to check wheth-
er the pilot flame lights. If the
pilot flame stays lit, the high-
limit thermostat has failed and
must be replaced. ]
Pilot (piezo-electric)
pushbutton igniter, if
present, does not light
the pilot flame
1. Electrode of igniter out of position or
dirty/sooty electrode.
2. Loose spark wire; loose igniter nut.
3. Piezo-electric igniter does not generate a
spark.
1. Move electrode within 3/16 of
pilot burner tip. Clean the
electrode.
2. Check spark wire connection at
the igniter nut and make sure
the connection is tight.
3. Replace igniter mechanism
(portion with pushbutton).
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire