Anetsberger-brothers 14G Manuel d'utilisateur télécharger pdf (Page 19)

19

FRYER TROUBLESHOOTING GUIDE (Continued)

PROBLEM CAUSE REMEDY

Pilot flame goes out

repeatedly.

1. Low gas supply pressure [less than 6”

W.C. for natural gas; (11” W.C. for pro-

pane) when all other gas-powered kitchen

equipment is operating].

2. Loose thermocouple or high-limit thermo-

stat connection(s) on gas control valve.

3. Pilot flame does not continuously touch

the thermocouple because of excessive

air flow around the pilot burner assembly.

4. High-limit thermostat problem has shut off

the gas.

1. Measure the gas supply pres-

sure.

Contact your local gas supplier

to obtain adequate gas supply

pressure.

2. Check and tighten the connec-

tions.

3. Block the excessive air flow to

make the pilot flame contact

the thermocouple.

4. Check for, and repair, any dam-

aged high-limit thermostat wir-

ing. [For model 14GSU fryer

ONLY: Press the reset push-

button on the high-limit thermo-

stat control. Perform the Light-

ing Procedure, to check wheth-

er the pilot flame lights. If the

pilot flame stays lit, the high-

limit thermostat has failed and

must be replaced. ]

Pilot flame does not

stay lighted. (Continued)

6. High-limit thermostat problem has shut off

the gas. (Continued)

7. Gas control valve has failed.

CAUTION: DO NOT return

the fryer to normal operation

with its high-limit thermostat

bypassed/disconnected.

!

6. (Continued)

For model 14GS, MX-14EG,

and MX14-EGU fryers ONLY:

Test the high-limit thermostat

by disconnecting the thermo-

couple at the gas control valve.

Then, disconnect the red wires

to the high-limit thermostat

from the gas control valve.

Reconnect the thermocouple;

next, perform the Lighting Pro-

cedure, to check whether the

pilot flame lights. If the pilot

flame stays lit, the high-limit

thermostat has failed and must

be replaced.

7. Replace the gas control valve.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire